Accessories

Experience Accessory Excellence

Accessories

Experience Accessory Excellence

LC-2000

The LC-2000 can be used for time-based cutting or it can measure products using an encoder with a measuring wheel.  The measuring wheel is designed to ride directly on the product being measured, or on the pinch roll or caterpillar belt of a feeder system.  The encoder sends a series of measurement pulses to the LC-2000 as it measures the product.  When the preset length count is reached the LC-2000 provides an output signal to the cutter to cycle the knife.  The counter is reset to zero and it continues to measure the product for the next cut.

When used with a high resolution encoder it receives one measurement pulse for every .002” of material movement, allowing it to hold extremely high cut length tolerance.

LC-2000

The LC-2000 can be used for time-based cutting or it can measure products using an encoder with a measuring wheel.  The measuring wheel is designed to ride directly on the product being measured, or on the pinch roll or caterpillar belt of a feeder system.  The encoder sends a series of measurement pulses to the LC-2000 as it measures the product.  When the preset length count is reached the LC-2000 provides an output signal to the cutter to cycle the knife.  The counter is reset to zero and it continues to measure the product for the next cut.

When used with a high resolution encoder it receives one measurement pulse for every .002” of material movement, allowing it to hold extremely high cut length tolerance.

Gap Indicator

Versa Pinch roll or belt gap indicators display the gap setting in 0.001” increments for improved ease of setup.

Encoder

Versa Machinery offers three different encoders that can be ordered for use with your LC-2000 system.

  1. V30383 provides 600 PPR
  2. 901354 provides 1,200 PPR
  3. V30377 provides 3,600 PPR

(Note: Older Versa Length controls were built to accept only one PPR rate encoder.  The encoder must be replaced with the same type. *PPR-Pulses Per Revolution)

Slide bases

Cutter slide bases are offered for both X and Y axis motion in a wide variety of sizes to make string-up quick and easy.

Knife and Bushing Lubrication

Drip Lube System are available with a variety of reservoir sizes, and independantly controlled feeds for lubrication of the knife and/or the cutter entrance bushing.

Knife lubrication reduces friction between the knife and product being cut, and helps keep product from sticking to the knife.

Bushing lubrication makes it easier for product to glide through the cutter bushings without restriction.

Request a Quote

preloder